Cisco Interactive Prompting
I got a kick out of this today. I was cleaning up some old 2500’s so that I could donate them. I booted one up and did a ‘write erase’… Read more »
ephone slot is already registered
The ProblemSo I got a couple more phones for the lab and after resetting them, I plugged them in and let them boot up. They booted to the standard phone… Read more »
CME Ringtone configuration
When we did our initial CME configuration we copied over the ‘ringtones.tar’ file and extracted it to the folder ‘CME_Ringtones’. Now it’s time to configure the CME instance to use… Read more »
CME – Dial Peers
A critical part of any CME setup are the dial peers. Dial peers are what are used to make calls in and out of the CME system. In modern telephone… Read more »
Cisco MQC (Modular Quality of Service)
I used MQC in an earlier blog post about NBAR but I didn’t spend much time talking about it. In this post, we’ll discuss MQC in greater detail. Cisco MQC… Read more »
CME – Configuring a SIP trunk
A typical type of outbound connectivity defined on a IP telephone system is a SIP trunk. SIP is Session Initiation Protocol which is, ironically, what it stands for as well. … Read more »